Skip to main content

Adjusting image height

Updated

These instructions vary between models. Recognizing your product

 

If your image is too low, you can use the Image Lift function to raise the projected image. This function raises the image digitally by shrinking it from the bottom up.

Note that reduced image size results in decreased image quality.

 

HW23x

Artome S-series

  1. With your Artome powered on, long-press FREEZE button to activate the Image Lift function.
  2. Freeze button starts blinking to indicate active Image Lift mode.
  3. Use VOL+ and VOL- buttons to adjust the image height.
  4. The image rises higher as it shrinks.
  5. Artome device can be moved backwards to enlarge the image but this decreases image quality.
  6. Exit Image Lift mode by pressing FREEZE button again or wait for automatic time out.
  7. Adjust the device focus if needed. Adjusting projector focus

Artome M10

  1. With your Artome powered on, long-press FREEZE button to activate the Image Lift function.
  2. Freeze button starts blinking to indicate active Image Lift mode.
  3. Use VOL+ and VOL- buttons to adjust the image height.
  4. The image rises higher as it shrinks.
  5. Artome device can be moved backwards to enlarge the image but this decreases image quality.
  6. Exit Image Lift mode by pressing FREEZE button again or wait for automatic time out.
  7. Adjust the device focus if needed. Adjusting projector focus

Artome X20

  1. Long-press freeze button on your Artome Remote to open the lens adjustments menu.
  2. The menu has three sections: focus, lens shift and zoom.
  3. Use the direction buttons to adjust the lens settings. Use the middle button or freeze to move between the sections.
  4. Exit the lens adjustment menu by pressing the menu or back button of the remote.
  5. You can also use the Epson remote to adjust the lens settings.

HW20

Artome M10

With your Artome powered on, press the FREEZE button to activate the Image Lift function.

  1. The image will freeze if there is active signal from any HDMI input. 
  2. Use VOL+ and VOL- buttons to adjust the image height.
  3. You will notice that the image shrinks as it rises higher.
  4. Artome device can be moved backwards to enlarge the image but this decreases image quality.
  5. Exit Image Lift mode by pressing FREEZE button again
  6. Adjust the device focus if needed. Adjusting projector focus

Artome X20

  1. Use Epson remote to adjust the lens settings.
  2. Use Lens Shift function to adjust the image height.

Related articles