This feature is supported by hardware version 231 and later. Recognizing your product
Audio Only mode allows you to use Artome as audio device without keeping on the projector.
Audio Only mode
You can use microphones, USB audio and HDMI audio of your Artome device by following these instructions.
- Turn on Artome by pressing POWER.
- Optionally: connect your laptop to HDMI and press SOURCE to select the desired input.
- Activate Audio Only mode by long-pressing SOURCE or press Audio Only button on the remote.
- The projector will now turn off. POWER and SOURCE buttons light up.
- Exit Audio Only mode by pressing POWER. To turn the projector back on, press SOURCE.
HW20 devices
You can use microphones and USB audio of your Artome device by following these instructions.
- Turn on Artome by pressing POWER.
- Connect USB cable to your computer or use the microphones.
- Select Artome Hybridock as output device on your computer.
- Press PAUSE button on your Artome to turn off the projector lamp.
Note: Epson projectors are set to turn off after 20 minutes if the projector is not used. You can disable this setting.
Artome M10: Menu > Operation > Sleep Mode: Off
Artome X20: Menu > Extended > Operation > Sleep Mode: Off